ERW Pipes

We offer ERW Pipes that are available in different sizes and shapes to suit the requirements of clients. The pipes and tubes of 4 inch size (10.2 mm) OD and below, strip is fed into a set of forming rolls which consists of horizontal and vertical rollers so placed as to gradually from the flat strip into a tube which is then allowed to pass the welding electrodes. Copper disks type electrodes are connected to the secondary of a revolving transformer assembly. These make contact on each side of the seam and temperature is raised to the welding point. With the use of cutting tool, the outside flash is removed as the tube leaves the electrodes. Inside flash is wiped out by an air hammer or by passing a mandel through the welded tube after the tube has been cooled. This is known as Electric Resistance Welded or ERW tube/pipe.

• High strength
• Corrosion resistance
• Durable
• Dimensional accuracy
• Fine finish

• Water pipelines
• Agriculture & irrigation (Water mains, sewerage systems, industrial water lines, plant piping, deep tube-wells & casing pipes)
• Gas pipe lines (Pipe lines for natural gas, LPG and other non-toxic gase
• The SW is meant for shallow water applications. This could be in a canal, natural stream, culvert, or pipe